Biz msds sheet

www.blendtech.biz 888-869-4827 714-698-3404 FAX BT EG HTF Ethylene Glycol Heat Transfer Fluid DESCRIPTION BTEGHTF heat transfer fluid is an inhibitor designed for use in applications where ethylene glycol/water mixtures are designed for use in hydronic systems. A mixture correctly blended with BTEGHTF is

TRADEASIA INTERNATIONAL PTE LTD 133 Cecil Street # 12-03 Keck Seng Tower, Singapore 069535, Republic Of Singapore Telp. +65 6227 6365 - Fax. +65 6225 6286 www.chemtradeasia.com

12/3/03 1 of 3 C:\Documents and Settings\Administrator\Desktop\MSDS SnoBiz.doc Material Safety Data Sheet Section I – Product Identification The sheets must be available at all times for review for informational and documentation purposes. Original MSDS sheets may be replaced with updated sheets, but the original information must be maintained identifying the substance and when and where it was used for the 30-year period.MATERIAL SAFETY DATA SHEET Stonebridge, West End, Pitney, Somerset. TA10 9AS. United Kingdom Tel. +44(0) 1458 259479 Mobile 07831 189311 E-mail: [email protected] 12/3/03 1 of 3 C:\Documents and Settings\Administrator\Desktop\MSDS SnoBiz.doc Material Safety Data Sheet Section I – Product Identification MATERIAL SAFETY DATA SHEET STEEL PRODUCTS Page 3 of 3 VII. SPILL OR LEAK PROCEDURES Not applicable to steel in the solid state. VIII. SPECIAL PROTECTION INFORMATION RESPIRATORY: For welding or burning - NIOSH/MSHA approved dust and fume respirators should be used to avoid excessive inhalation of particulates.Products Regulations (CPR) and the MSDS contains all of the information required by the CPR. To the best of our knowledge, the information contained herein is accurate. However, Statikil, Inc.assumes no liability whatsoever for the accuracy or completeness of the information contained herein.

Information presented on this Material Safety Data Sheet is believed to be accurate at the time of publication. No warranty, expressed or implied, is made with regard to this information. This information may not be adequate for every application, and the user must determine the suitability of this